Login
My Account
My Cart
The site navigation utilizes arrow, enter, escape, and space bar key commands. Left and right arrows move across top level links and expand / close menus in sub levels. Up and Down arrows will open main level menus and toggle through sub tier links. Enter and space open menus and escape closes them as well. Tab will move on to the next part of the site rather than go through menu items.
Enter your truck info so we can recommend the right products for you.
Can't find it? Call us at 859-737-4966 for free advice.
Menu
Injection Pump
Injector
Programmers
Turbo Charger
Banners
Decals
Hats
Hoodies
License Plates
Shirts
Tank Tops
Show your support with a Thoroughbred Diesel t-shirt, sweatshirt, or sticker decal.
Thoroughbred Sku #: HAMFIRERINGHEADGASKETS0718DG
Product Name: Hamilton Cams Fire Ring Head Gasket - 07.5-18 Dodge 6.7L Cummins Manufacturer: Hamilton Cams Thoroughbred Diesel Part #: HAMFIRERINGHEADGASKETS0718DG Fitment Notes: 2007.5-2018 Dodge Cummins 6.7L
If you are making over 700+ HP in your 2007.5-2018 Dodge 6.7L Cummins upgrade to Hamilton Cams Head Gaskets. Provides a much stronger seal and help eliminate the normal head gasket problems found on higher boost levels.
For best results please have your head and block machined prior to installation for flatness. For engines under 800hp, cutting grooves in the head or block is adequate, but for higher horsepower engines we suggest cutting grooves in both the head and block. We suggest a radiused cutter for all installations. Studs are a must for proper clamp load. Our rings are made from .105” wire and are 4.560” in diameter. When using our competition gasket, studs are a must. Be sure to use a liberal amount of lubrication on the nut, washer and threads of the studs so that every stud sees similar clamp load. If lubrication varies stud to stud, clamp load on gasket will not be equal and can allow gasket failure. Never under any circumstances, should you take a fastener beyond the limits listed by the manufacturer. There is a huge amount of potential energy in fasteners at full torque. We suggest 130 ft/lb of torque for initial startup. Get engine to operating temperature, then retorque while hot. You should check valve lash after each torque sequence as re-torques crush the head gasket more and will make valve lash less. It is always a good idea to re-check torque at least one more time before you take engine to full load/rpm. Thank you for purchasing Hamilton products for your diesel.
Hamilton Cams Features:
For best results please have your head and block machined prior to installation for flatness. For engines under 800hp, cutting grooves in the head or block is adequate, but for higher horsepower engines we suggest cutting grooves in both the head and block.