ats-6019002464-1
ats diesel

ATS Co-Pilot Transmission Controller - 19-22 Dodge 68RFE

Thoroughbred Sku #: ATS6019002464
Manufacturer Sku #: 601-900-2464

Item Options:

Prop 65:
WARNING: Cancer & Reproductive Harm - P65Warnings.ca.gov


$795.00

free-shipping-no-handling

Applications:

View All applications

VERIFY VEHICLE FIT

Product Details

Product Name: ATS Co-Pilot Transmission Controller - 2019-2022 Dodge 68RFE
Manufacturer: ATS
Manufacturer Part #: 6019002464
Thoroughbred Diesel Part #: ATS6019002464
Fitment Notes: 2019-2022 Dodge 68RFE
Warranty Information: 5-Year/500,000 Mile Limited Warranty

The 68-RFE is plagued by small clutch packs, weak hard parts, constant slip torque converter lock-up, and inadequate line pressure. Typically, these issues can result in the failure of the stock transmission with only a mild tune or heavy trailer. The Co-Pilot Tow Edition addresses these concerns.

The Co-Pilot consists of a controller, harness and secondary electronics box. The harness plugs into the main transmission connector on the valve body and is completely plug and play for easy installation. The controller mounts in the cab, and allows the driver to view critical transmission and engine inputs such as line pressure, and both commanded and actual engine load. Viewing the different sensor inputs is as easy as pressing the up or down arrows. These changes can be made on-the-fly or with the vehicle stopped. The secondary electronics box is mounted to the drivers side frame and requires no cutting or fitting.

The Co-Pilot controls line pressure, clutch timing and more aggressively applies the converter clutch under high torque situations. Line pressure is limited in a stock 68-RFE to 160 PSI. Unfortunately, this is not nearly enough to reliably prevent clutch slippage above 400hp. The Co-Pilot reads boost pressure and throttle position to quickly take control of line pressure when it is needed. However, when the vehicle is driven lightly, line pressure is near stock for comfortable shifts. This is all done automatically in the controller. Line pressure is increased dramatically with the addition of an ATS Valve Body Full Pressure Enable Kit. This kit is already installed on any 68-RFE transmission built in-house at ATS, and can also be installed on a stock transmission to safely allow line pressure to increase up to 270 PSI. While the installation of the kit isn't necessary, it will increase the performance of the Co-Pilot to its fullest potential. We recommend installing one of our modified valve bodies to fully address all of the internal hydraulic issues with the 68-RFE valve body.

The Co-Pilot has a huge advantage over TCM programing on 2013 and newer trucks because of the way the factory TCM is designed. When the higher line pressure modifications are done to the valve body on a 2013+ truck, aftermarket TCM tuning that is used will cause a radical pressure variation that spikes line pressure causing many problems. For this reason you will find TCM tuning is less desirable on these newer trucks. When TCM tuning is used, the tuners do not allow for full line pressure increases. The ATS Co-Pilot, utilizing its dynamic closed loop control addresses this with an averaging circuit that provides a very smooth and controllable line pressure rise up to 270PSI. Clutch timing is programmed into the Co-Pilot and crucial to clutch pack life. On any 68-RFE transmission, clutch timing is optimized to reduce wear on clutch packs, efficiently transfer power and increase reliability. The torque converter lock-up apply on a stock 68-RFE leaves a lot to be desired. The factory TCM will command lock-up at a very low speed when at light throttle, this causes a sluggish condition, low boost and poor drivability. The ATS 68RFE Co-Pilot will more firmly lock the converter clutch during apply, this allows the inherent torque of the Cummins engine to be used for improved efficiency and performance.

Modes Available in Co-Pilot:

  • Setting 1 (down or all the way to the right) This mode shows you TPS position. No lights = 0% and 5 lights = 100%
  • Setting 2 (one position from far right) This mode shows you what the boost sensor sees. No Lights = 0 PSI boost and 5 lights = 40 PSI boost
  • Setting 3 (two positions from the right) This mode shows you actual transmission line pressure. No lights = 100 PSI line pressure and 5 lights = 260 PSI line pressure.

ATS Co-Pilot Transmission Controller Features:

  • Setting To Choose From 
  • Increases Line Pressure To 270 PSI
  • Automatically Adjusts Line Pressure
  • For more information on ATS call us at 1-859-737-4966

Reviews

  • Co-polit how does it work and how do I use it do I only use it when towing?

    Kale | 7/22/2023

    The ATS CoPilot provide you the ultimate in push-button control over when the torque converter locks up in your vehicle, allowing you to select the vehicle speed where the torque converter clutch will engage (lock up) and disengage. Your truck's factory programming doesn't initiate lock up until cruising speed and disengages lock up early under many conditions, inhibiting your truck's performance. The Commander and Co-Pilot resolve this issue by holding lock up offering better acceleration and cooler transmission running temperatures.

  • Will it work with out a ecm? Thanks

    Billy | 10/30/2022

    No

  • I recently bought an ats stage 3 from you folks for my 01 dodge 3500. I’ve hooked up the copilot and doesn’t seam to do anything other than my converter won’t lock up at all. And when I shut the controller off I lose my speedometer. I’ve double checked all my connections and I don’t run any other programmer. Computer has never been touched. I’ve owned this truck since it was new. Any suggestions would be great.

    Mark dodge | 4/19/2022

    If you are sure the installation is correct.contact Ats tech support @(866) 209-3695