 |
|
 |
|
 |
|
 |
|
|
|
|
|
|
|
|
|
 |
|
|
|
 |
|
|
 |
 |
|
|
View My Cart |
|
Checkout Now |
 |
|
 |
|
 |
| VP44 injection pumps |
 |
| Edge Products |
 |
| Diablo Predator |
 |
| S&B Intakes |
 |
 |
BD
Diesel Performance Injectors
|
 |
GM Injector |
| The 6.5 injector is referred to as a pintle style injector, which is commonly used in an engine with pre-combustion cylinders. The injector has a needle plunger that plugs off the spray hole when it is closed. Once the pump allows fluid flow to the particular cylinder, the high fuel pressure forces the pintle away from the hole seat and the fuel stream is injected through the pre-combustion chamber into the combustion chamber. This type of engine often runs dirtier than a direct injected engine and the injectors require replacing between 80-100 thousand miles. |
|
Choose your GM Truck Below | Shipping | Quantity |
Order |
 |
Dodge High Flow
Injectors |
High Flow Injectors It’s a fact—some Bosch fuel nozzles inject more fuel and make more power than others. Let BD’s 31 years of fuel injector experience work for your 1991-’98 Cummins 5.9 liter 6BTA 12-valve or ISB 24 valve engine with a calibrated fuel injector kit. Included with the kit is a metered turbocharger waste gate orifice that increases turbo boost for the correct air fuel ratio and significant power gains of 20-40 rear wheel horsepower, depending on the application. For high-performance and race applications, BD now offers its X-Pulse injectors, which have been manufactured with and extra hole in the nozzle to increase fuel delivery beyond stock specifications. These new injectors produce 30-50 rear wheel horsepower, while BD XXX-Pulse injectors produce 60-90 rear wheel horsepower. When choosing BD XXX-Pulse injectors, BD recommends electronic engine timing modifications and a power matched turbocharger. In addition, modifications to the drivetrain to handle the extra torque load may be necessary. Please call for details. |
|
Choose your Dodge Truck Below | Shipping | Quantity |
Order |
| *** WARNING these injectors are for extreme/race use only and may cause excessive smoke/heat | ||||
 |
Ford Injectors |
|
BD now offers Brand NEW Powerstroke injectors that are manufacturered to Ford, Caterpillar and Navistar specifications. Only new current production has tungsten coated plungers that prevents any sticking and increase the injector life. They test as new and perform as only a new part built to high quality standards can. Warranty is 2 Years on the parts and one year labor coverage. Core charges do apply but are credited 100% on prompt return. BD's rebuilt injectors are tested and verified electronically and then mechanically calibrated in matched sets. The injector is checked for fuel flow at different levels to duplicate idle, mid and high engine rpm and load. The Nozzle spray pattern is inspected and the release pressure is set. Matting surfaces are lapped to ensure no leakage occurs within the body. The XXX Pulse injectors add 80 more rear wheel Hp. When using these high performance injectors we suggest a X Power chip with special engine tuning be installed to adjust the time of injection that insures a good clean fuel burn as well as good operating temperatures. A new High flow quick responce turbo is also required. Any year PowerStroke cores will be accepted. Fire damaged units will result in the core being rejected. |
|
Choose your Ford Truck Below | Shipping | Quantity |
Order |
123 Westside Drive
Winchester, KY 40391
Copyright © 2003-2008 Thoroughbred Diesel All rights reserved.
Site map