Diesel Trucks ABOUT US | RETURNS FORM | POLICIES | FAQ'S | VIEW CART | CHECKOUT
100% customer guarantee
join our newsletter Thoroughbred Diesel
brands performance accessories stock parts tractor parts
Click to see all the Black Friday Cyber Monday Deals
customer guarantee
shop by diesel
shop by
Thoroughbred Apparel
read our low price guarantee
click here for diesel truck gallery
gift cards
diesel resource guide
TS Performance logo

TS Performance Chip Installation

TS switchable chip knob
free shipping special with no handling fees
Click Here To Order
NOTE: The factory speed limiter has been raised! It is the customer’s responsibility to make sure that the tires have proper speed rating.

Read and fully understand all instructions before attempting to install the TS Performance Chip. When calling for technical help, have the Business card provided with your chip handy. It will be needed to verify your programs.
  1. Remove the keys from the ignition and disconnect both batteries. Failure to do so may cause damage to the computer and chip
  2. Locate the factory computer inside the cab. On 99-03 Trucks the computer is located beside the emergency brake bracket. On 95-97 trucks the computer is located behind the emergency brake bracket. To remove the bracket remove the (3) 13mm nuts from the bracket. For 95-97 trucks skip to step #7.
  3. On the 99-03 trucks you must now locate the wiring harness on the fire wall in the engine compartment that goes to the factory computer. It is the harness closest to the fender and has a 10mm bolt holding it to the computer. Remove the 10mm bolt and slide the connection out of the firewall.
  4. Go back inside the cab and remove the (2) 7mm bolts holding the computer in place. If your truck is a manual, remove the 10mm nut from the bottom of the bracket holding the computer and the 10mm bolt holding the top.
  5. Once you have the computer loose, slide the computer and bracket out slowly.
  6. Remove the computer from the plastic housing and remove the cap to expose the terminals
  7. The terminals are coated in a rubberized protective coating. Use the supplied Scotch Brite Pad and Lacquer thinner to remove the coating. You will also need to use a small flat head screw driver to scrape the terminals. Repeat this process 2-3 times to make sure you get a clean connection. Remember 95% of problems with the chip are due to insufficient cleaning of the connection.
  8. Once you feel the connections are good and clean, place the chip on to the terminals. If you purchased a multi-position chip you will need to plug the switch into the chip first.
  9. Now slide the computer back into the plastic housing with the side of the computer with an “X” positioned toward the fender. Replace the bolts you removed earlier holding the computer in place.
  10. Now reattach the wiring harness going through the firewall and tighten the 10mm bolt.
  11. Reconnect the batteries and start the truck.
  12. If the truck fails to start, remove the computer again and try cleaning the terminals again.
REMEMBER THIS IS A HIGH PERFORMANCE PRODUCT. USE AT YOUR OWN RISK. FOR OFF ROAD USE ONLY.

Do not use this product until you have carefully read the following agreement. This agreement sets forth the terms and conditions for the use of the TS Performance product. The installation of this product indicates that the buyer has read and fully understands this agreement and accepts its terms and conditions.

 
Thoroughbred Diesel logo glowing Thoroughbred Diesel Performance and Repair Shop
4843 Rockwell rd.
Winchester, KY 40391
Call Toll Free: 1-866-737-4966

Email:
sales@thoroughbreddiesel.com
Copyright© 2003-2014 Thoroughbred Diesel All rights reserved.
Site Map
Thoroughbred Diesel is an Upfront Merchant on TheFind. Click for info.
     
100% customer guarantee