*NOTE:
Phone lines will be closed Saturday 3/17 due to equipment upgrades.
Normal schedule will resume Monday! Feel free to order online
as the site will remain up and running.
Snow
Performance Safe Injection
For
years, many have wanted to use water/methanol injection but have not
taken advantage of the power increases do to safety concerns. Designed
as an ad-on to the Boost Cooler® water/methanol injection system,
Safe Injection™ provides for a safe tune in those instances
where no injection is present and an aggressive tune is utilized.“
This system reduces boost or timing anytime injection quantity goes
below a set point (e.g. if reservoir level goes too low) making the
tune instantly conservative for the ultimate in safe water/methanol
injection.
Operation
The SI-10 and SI-05 monitor the flow of Water/Methanol in
the system. When flow drops below 0.10 Gallons per Minute
(GPM), equal to 378 ml/min,( 0.05 GPM or175ml/min on the SI-05)
the fault trigger will go to a high state of 12 volts. In
addition to the supplied red LED, this trigger can be used
to signal the following:
1. an ignition/timing controller such as an MSD timing computer
if using an MSD ignition
2. aftermarket engine computer
3. a solenoid such that boost is reduced in a wastegated turbo
set-up. ( $39.95 list. See below.)
4. a solenoid to evacuate boost on a supercharged set-up.
The trigger signal can deliver up to 1.5 amps to drive a solenoid
or relay.
