digital DSP-5 switch is encased in a standard 2 1/16"
gauge pod housing for an easy/clean/no-drilling/cutting
install anywhere that a standard 2 1/16" gauge will
fit, such as an A-pillar mount, overhead mount, cubby hole
mount, etc. The tune control buttons are back-lit for easy
access/viewing at night. Installation is very easy, with
only 4 wires to hook up.
included is the "valet" mode. This is an extra
"signal wire" that, when grounded, locks the DSP-5
switch into the stock-tune. Regardless of which buttons
are pushed, or if the truck is restarted, as long as the
valet-signal wire is grounded, your truck and engine is
safe from any abusive drivers that you might lend your truck
to! Several methods of terminating the wire are either a
simple hidden toggle switch under the dash, or a full key-lock
switch. This can also be used as a "no-start"
anti-theft switch so when the hidden toggle switch is flipped,
the truck will not start.
settings can be programmed by the end user as well, such
as "tune recall" (you can set the DSP-5 switch
to recall the last tune that was selected when the truck
is restarted, or you can set the DSP-5 switch to always
revert back to stock tune at each key-cycle), and "tune
reversal" (you can set the DSP-5 switch to run the
tunes in reverse, in case your tuner has your "race
tune" in the "stock tune" tables instead
of "DSP #4" tables in EFILive).
wiring, as well as the appropriate ECM pins are included
with the kit!