|
The Edge Comp module maximizes engine efficiency
by monitoring the RPM, timing, turbo boost pressure and fueling
parameters of your Cummins engine. The Comp module uses this
information to determine and control both fueling and timing
enhancements for the Bosch fuel injection pump. Timing and
fueling enhancements are controlled via CAN-BUS through the
Data Link and by connecting directly into the Bosch
fuel injection pump.
The
Edge Comp features five power levels with power gains from
40-120 horsepower. Each of the levels has five independent
adjustable sub-levels to control low boost fueling, providing
a total of 25 levels of adjustability! The responsiveness
settings enable you to dial-in the optimum balance between
responsiveness and low boost smoke control no matter what
additional power modifications have been made to the engine.
The Comp module is fully adjustable on-the-fly and mounts
inside the cab.
The following
power gains are representative of an actual test vehicle.
These gains were measured on a SuperFlow Dyno at an altitude
of 4400 ft above sea level, and represent power delivered
to the rear wheels of the test truck. The only modification
made to the test truck was the addition of the Edge Juice
module. Power gains may vary based on vehicle and geographical
location.
Level
0: Stock
Level 1: 40 Horsepower - 150 Foot Pounds of Torque
Level 2: 60 Horsepower - 200 Foot Pounds of Torque
Level 3: 80 Horsepower - 250 Foot Pounds of Torque
Level 4: 100 Horsepower - 300 Foot Pounds of Torque
Level 5: 120 Horsepower - 350 Foot Pounds of Torque
Not legal
for sale or use in California on pollution-controlled motor
vehicles.
|
