IBD's ProTect 68 Trans Pressure Control kit adds 150% of the torque
holding force to stock transmissions like no others can. Kit
includes a newly designed valve body separator plate and a
Pressure Control module that delivers up to 250 PSI clutch
apply pressure providing 150% of the holding force above stock
to prevent clutch slippage. All of this without modifying
the transmission pump or removing the transmission.
ProTect 68 Electronic Pressure Controller dynamically adjusts
the hydraulic apply pressures based on turbo boost/ engine
load. The module's dynamic control ramps up the much larger
sweep right up to 250 PSI mainline pressure as needed - dependent
on engine load which creates turbocharger boost dynamically.
This is not accomplished with any other aftermarket engine
takes 2-to-3 hours to complete without having to do a full
transmission relearn since no internal tolerances have changed.
A “fresh" stock transmission will have the ability
to handle up to 500hp. For higher power or demands, a complete
BD 68RFE transmission with additional clutches and new designed
components is recommended.
from BD for the 68RFE transmission, Heavy Duty Trans Pan,
Triple Torque Force Torque Converters and Build-It rebuild