6.4L
DPF Selection
The DPF or Diesel Particulate Filter is part of the factory
exhaust system on the 6.4L Powerstroke. H&S offers tuning
that allows the DPF to be left in place, or removed completely.
If you
are planning on leaving the exhaust system stock with the
DPF in place, you will select PRESENT.
If you
have already removed the DPF or if you plan on removing the
DPF immediately after installing your H&S tuning device,
you will select REMOVED. If you select REMOVED, you must Accept
our DPF Disclaimer in order to continue with the Install Download
process.
6.7L DPF Selection
The DPF or Diesel Particulate Filter is part of the factory
exhaust system on the 6.7L Powerstroke. H&S offers tuning
that allows the DPF to be left in place, or removed completely.
If you
are planning on leaving the exhaust system stock with the
DPF in place, you will select PRESENT.
If you
have already removed the DPF or if you plan on removing the
DPF immediately after installing your H&S tuning device,
you will select REMOVED. If you select REMOVED, you must Accept
our DPF Disclaimer in order to continue with the Install Download
process.
6.4L DPF / Exhaust Sensors
When running DPF PRESENT tuning, it is required that all sensors
located in the exhaust system stay in place and plugged in,
otherwise you may experience a Check Engine Light (CEL) and
even a loss of power (limp mode).
When running
DPF REMOVED tuning, it is recommended that all sensors located
in the factory exhaust system be unplugged from the electrical
harnesses. These sensors can also be removed completely with
the factory exhaust if desired. On the 6.4L Powerstroke, there
are usually 2 EGT Sensors and 1 Pressure Sensor.
Note: The vehicle will not run with sensors removed
unless DPF REMOVED tuning is installed.
6.7L DPF / Exhaust Sensors
When running DPF PRESENT tuning, it is required that all sensors
located in the exhaust system stay in place and plugged in,
otherwise you may experience a Check Engine Light (CEL) and
even a loss of power (limp mode).
When running
DPF REMOVED tuning, it is recommended that all sensors located
in the factory exhaust system be unplugged from the electrical
harnesses. These sensors can also be removed completely with
the factory exhaust if desired. On the 6.7L Powerstroke, there
are usually 3 EGT Sensors, 1 NOX Sensor, 1 UREA Injector,
and 1 Pressure Sensor.
Note: The vehicle will not run with sensors removed unless
DPF REMOVED tuning is installed.
6.4L EGR Unplug / Delete
When running H&S DPF REMOVED tuning, it is not required
to unplug or block-off the EGR system on your 6.4L Powerstroke
to disable it. The EGR system is already disabled in the tuning
and will not function under any conditions. If desired, the
entire EGR system can be unplugged, blocked-off, or completely
removed when running H&S DPF REMOVED tuning.
6.7L EGR Unplug / Delete
When running H&S DPF REMOVED tuning, it is not required
to unplug or block-off the EGR system on your 6.7L Powerstroke
to disable it. The EGR system is already disabled in the tuning
and will not function under any conditions. If desired, the
entire EGR system can be unplugged, blocked-off, or completely
removed when running H&S DPF REMOVED tuning. |
