aFe BladeRunner turbocharger supports up to 600HP while reducing
Exhaust Gas Temperatures (E.G.T.).
The ported shroud design of the A356 aluminum housing utilizes
a 4.0"" inlet and OE v-band outlet. The compressor wheel measures
84mm (64 trim). The CNC machined wastegate actuator is mounted
to the integrated cast bracket.
The internally wastegated, high silicone ductile iron
housing has an A/R of 0.84. The high-flow turbine outlet helps
to lower exhaust gas temperatures (EGT's). The larger than OE
turbine wheel measures 74mm (75 trim). The wastegate comes preset
to 40 psi.
Replacement: The included ductile iron exhaust elbow
allows this turbo to be installed on 1994-2002 model years.
All connections to the vehicle are compatible with the OE geometry,
resulting in a quick and reliable connection. Additional fueling
is not required for improved performance over OE, but maximum
gains are achieved from fuel system upgrades, either electronic
Turbocharger Downpipe (optional) - Part # 46-60066
Direct Fit to aFe P/N: 46-60061 and
46-60062. Will not work with factory exhaust or factory turbo.
If the cast elbow is installed it must be removed.
Installation: Utilizing the factory mounting
locations providing stability and a direct fit.
Leak-Free Seal: High quality CNC machined flange
is used for a complete 360 degree sealing surface.
This is a "Race Only" product used solely for competition.
Its use is limited to closed-course and open-course racing that
is formally sanctioned by a recognized racing organization.
Any other use including recreational off-road use could be in
violation of local, state and federal laws.
This product CAN NOT ship to California due to CARB regulations.